Mono/Stereo Mode

Here are step by step instructions on how to set up mono or stereo operation directly on the pedal. You can also set the mono/stereo mode (and much more) from Keystone Control Center.

• Use TS (Tip/Sleeve) cables for mono connections, and TRS (Tip/Ring/Sleeve) cables for stereo connections. 
• Hold down FS2 (left footswitch) as 9V power is applied to enter mono/stereo setting mode.
• Set Toggle 3 (the bottom toggle, nearest the footswitches) to the desired setting:
• UP (Stereo input / Stereo output -- LEDs show BLUE/BLUE) 
• MIDDLE (Mono input / Stereo output -- LEDs show RED/BLUE) 
• DOWN (Mono input / Mono output -- LEDs show RED/RED)
• Press SW2 again to exit mode setting, and begin using the pedal. Light 2 will first quickly blink to confirm the mono/stereo mode you set.
• Stereo/Stereo - three blinks
• Mono/Stereo - two blink
• Mono/Mono - one blink

Once completed, the blink code will display at every startup to show the current mono/stereo setting.